Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramKeyless.com to have the most current and accurate information. ProgramKeyless.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

1997 Ford Econoline Key Fob Programming Instructions

1997 Econoline

  1. Turn ignition to RUN or ACC.
  2. Jump pins in programming connector plug for entire programming procedure. All doors will lock then unlock to confirm programming mode. (The plug is black with two wires: white with yellow stripe and gray with yellow stripe. The plug comes out of a large harness which runs under the column at the bottom edge of the dash.)
  3. Press any button on first keyless remote. Doors locks will cycle to confirm programming.
  4. If programming second keyless remote press any button on it and door locks will cycle to confirm programming.
  5. Turn ignition to OFF. Door locks will cycle to indicate end of programming mode.
  6. Remove jumper wire in programming connector.