1998 Accord
Note:
Entering the programming mode cancels all learned keyless remotes, so none
of the previously programmed remotes will work. You must reprogram all of the
keyless remotes once you are in the programming mode.
You must complete each step within 5 seconds of the previous step to keep the
system from exiting the programming mode.
- Turn ignition switch to ON (II)
- Press the LOCK or UNLOCK button on one of the remotes. (An unprogrammed remote can be used for this step.)
- Turn ignition switch to LOCK (0)
- Repeat steps 1, 2 and 3 two more times using the same keyless remote used in step 2
- Turn the ignition switch to ON (II)
- Press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirm you are in programming mode.
- Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.
- Turn the igniton switch to LOCK (0) to exit programming mode.
- Test remote(s)