Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramKeyless.com to have the most current and accurate information. ProgramKeyless.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

1996 Oldsmobile Cutlass Supreme Key Fob Programming Instructions

1996 Cutlass Supreme

Note: Existing keyless remotes will be erased with this procedure. Existing working remotes will have to reprogrammed also.

  1. Locate the programming connector wire located in the RH trunk area. You may have to pull back right side trunk trim on trunk wall to locate the single black/white wire.
  2. The programming connector wire should have one termial in the plastic connector on end of black/white wire. Ground the terminal in the connector to a nearby bolt or trunk latch.
    Leave connector wire connected to ground through out procedure.
  3. System will now lock and unlock doors automatically to indicate programming mode has been activated.
  4. Press any button on keyless remote. System will respond by locking and unlocking doors one time to indicate successful programming.
  5. Repeat step 4 for to program any additonal keyless remotes including and existing keyless remotes. Do not remove ground wire between programming of keyless remotes.
  6. Disconnect programming connector wire from ground to exit programming mode.
  7. Test keyless remote(s).